![image bucket hitting head image bucket hitting head](https://cdn.shutterstock.com/shutterstock/videos/7603366/thumb/1.jpg)
If the tensioning device cannot fully tensify the bucket belt, it means that the travel of the tensioning device is too short and should be adjusted again.ģ.2 When overloaded, the resistance moment increases, causing the belt to slip. The head pulley and tail pulley wear seriously, need to repair or replace it in time.ģ.1 Not enough tension in the belt causes to slip. The vertical deviation of the belt bucket elevator is too large, the head pulley and the tail pulley are not parallel, leading to the deviation of the bucket belt, and easy to cause the collision between the bucket and the pulley, and the tearing of the bucket belt.Ģ.
![image bucket hitting head image bucket hitting head](https://i.ytimg.com/vi/nVPuvZCffJI/maxresdefault.jpg)
At this time we should stop, fix connector joint.Ģ. It causes the bucket belt to move to the tight side, then causes the deviation. The edge of the bucket belt is not in the same line, in production and operation, bucket belt one side tight, the other side loses. In production, steel mesh or magnet should be installed at the inlet to prevent large foreign bodies from falling into the machine base.Ģ.
#IMAGE BUCKET HITTING HEAD CRACK#
1.1 Generally, the bucket belt falls off and the process of bucket runs off are particularly easy to cause the bucket belt to tear, the causes should be found out in a timely and comprehensive manner.ġ.2 Mixing foreign bodies with sharp edges in the material will also crack the bucket belt.